27
DO985RKC
www.domo-elektro.be
EN
· The appliance must be grounded. The manufacturer is not responsible for damages that may occur as
a result of usage without grounding.
· For uneven surfaces, front feet can be aligned.
· After installation, leave the freezer for 8 hours before turning it on. This way the refrigerant can settle.
· Allow the appliance to run empty for 24 hours so the compartment can cool to the appropriate
temperature.
· This appliance is designed to operate in ambient temperature between 16°C and 38°C. If these
temperatures are exceeded, i.e. colder or warmer, the appliance will not operate correctly.
· The appliance may only be used indoors.
TEMPERATURE CONTROL
· The internal temperature can be controlled by the thermostat, which can be set to 8 different
positions. 1 is the warmest setting and 7 is the coldest. To turn off the appliance, set the temperature
control to ‘0’.
· Operating time and temperature are affected by where the refrigerator is used, the number of times
the door is opened and the temperature of the room it is in.
USE
STORING FOOD IN THE FRIDGE
The fridge helps to extend the storage times of fresh perishable foods. Fresh food care for best results:
· Store foods that are very fresh and of good quality.
· Ensure that food is well wrapped or covered before it is stored. This will prevent food from
dehydrating, deteriorating in colour or losing taste and will help maintain freshness. It will also prevent
odour transfer.
· Make sure that strong smelling foods are wrapped or covered and stored away from foods such as
butter, milk and cream which can be tainted by strong odours.
· Cool hot foods down before placing them in the fridge.
MOVING YOUR APPLIANCE
If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will allow
the refrigeration system pressures to equalise before restarting.
· Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile
parts (shelves, accessories, etc.) or fix them into the fridge to avoid any shock.
· Relocate and install. If the appliance has been left on its side for any length of time, leave it standing
upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly
and natural gas, it is explosive. Therefore you should be careful during shipment and installation to
prevent your appliance’s cooler elements from being damaged. In the event of a leak caused by damage
to the cooler elements, move your fridge from open flame or heat sources and ventilate the room where
the appliance is located for a few minutes.
