SYSTEM PROGRAMMING
Following are instructions for programming each Area of the
AM/II memory. Only the Areas pertaining to the specific
installation need to be programmed. Reference the following
pages with the programming outline to complete the system
programming.
The AM/II must be in Program Mode to perform any system
p r o g r a m m i n g . F O L L O W T H E S T E P S I N T H E
PROGRAMMING OUTLINE TO PROGRAM THE SYSTEM.
Because many of the features of the AM/II are interrelated,
certain areas must be programmed before other areas.
Entering Program Mode
STEP 1 Enter programming mode by pressing and holding
the [
*
] key for about five seconds. With computer
access press the ESC key.
STEP 2 Enter 123456 (if the system is new), or the correct
password and press [OK].
Exiting Program Mode
Exit Program Mode by pressing and holding the [
*
] key for three
seconds. With computer access, press CTRL-Z.
☞
NOTE: The system will automatically exit Program Mode
after five minutes of programming inactivity.
U P & D O W N
A R R O W S W I L L
M O V E B E T W E E N
M E N U T O P I C S
[ O K ] K E Y S E L E C T S
S U B - M E N U S
L E F T & R I G H T
A R R O W S W I L L
M O V E B E T W E E N
M E N U I T E M S
B L I N K I N G I T E M
I S T H E O N E
C U R R E N T L Y
S E L E C T E D
[ O K ] K E Y E N T E R S
S E L E C T E D M E N U
I T E M I N T O
M E M O R Y
[ O K ] K E Y E N T E R S
N U M E R I C D A T A
I N T O M E M O R Y
OK
AREA 01
SINGLE TRANSMITTERS
Learn Single Xmtr(s)
Press OK when Ready
1.1
1.2
1.3
1.4
1.5
1.1B
1.1A
Select Validation Group.
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Learning Transmitters
Transmitter ID: = 0001
Enter Single Xmtr Numb
Enter Xmtr. ID: 000
Suspend Single Xmtr.
Transmitter ID: = [0000]
Reactivate Single Xmtr.
Transmitter ID: = [0000]
Delete One Single Xmtr.
Transmitter ID: = [0000]
Status of Single Xmtr.
Transmitter ID: = [0000]
1.7
1.5A
Item/Code:
Press OK When Ready
1.6
Enter Expiration Date.
Expires On: mm/dd/yyyy
Delete All Single Xmtr.
Are You Sure? Yes No
1.8
37
