AERO.100 User Guide
©2016 TLS Corp. ALL RIGHTS RESERVED
Oct 2016
Page 63
5
5
5
5
Logs and
Logs and
Logs and
Logs and Control Scripts
Control Scripts
Control Scripts
Control Scripts
Logs and control scripts are found in the AERO.100 HTTP server. To access the HTTP server in
your AERO.100 your PC ’s IP address must appear in the AERO.100’s HTTP white list in order to
have access to the built in HTTP server. If this has not been done yet refer to section 4.4.
The script feature is new to version 3.15.26. A script is a series of parameter change commands
that can be named and saved as a Task. These tasks can then be assigned to any of the
available GPIs. Any command that is available through the AERO.100 HTTP server, as an IP
based command, can be placed in a script and saved as a task. Now GPI control can be used to
change any parameters, in any combination. The possibilities are nearly infinite.
5.1
5.1
5.1
5.1
HTTP Server
HTTP Server
HTTP Server
HTTP Server Access
Access
Access
Access
To access the AERO.100’s HTTP server use any browser and enter the AERO’s IP address and the
HTTP server port, 7380. For example: 192.168.1.12:7380
Note!
MS IE requires the entry of: http://192.168.1.12:7380
The HTTP server page that will open is shown in Figure 5-1.
Figure 5-1:
HTTP Server Home Page
