Linear Acoustic LAMBDA-II Audio Monitor User Guide
Detailed Operation
23
NOTE: In PCM-16 via BNC or PCM-16 via SDI audio signals are mapped as applied
to inputs. Front panel Solo and Downmix controls allow simple and quick se-
lection of specific channels or groups for monitoring.
Each program can then be quickly switched between by using the up and down
buttons on the Menu navigation cluster. Note that next to each of the eight BNC
Inputs is a mini channel presence bargraph for easily determining if a channel pair
has audio.
•
L/R -
Used for stereo or dual mono audio sources
•
lf/rf; c/s; ls/rs -
Used for setup of each pair within a 5.1 channel program:
Left front/Right front, Center/Subwoofer, Left surround/Right Surround
•
C/C -
Used for 1+1 mono programs where the two channels contain different
audio.
•
Pgm 1-8 Settings -
Selects whether to apply or not apply the dialnorm audio meta-
data parameter to the selected program.
•
Apply DRC (DD) -
Selects whether to apply or not apply the Dynamic Range
Control words from an applied and decoded Dolby Digital (AC-3) signal. If pres-
ent in the encoded bitstream, These control words apply dynamic cut and boost to
the decoded audio. The actual gain words can be observed in the Metadata menu.
•
Edit Preset Name -
Change the name of the current preset.
Input Mode
Speaker
Mute
BNC Inputs
Program
Assignment
Monitor Ch
Assignment
Channel
Level
Summary of Contents for L.A.M.B.D.A.-II
