Linear Pro Access LPWWS, Installation And Programming Instructions

3

LPWWS | Installation Instructions 

Wire the Wall Station

Always unplug the opener head unit’s 

AC power cord before wiring or 

repositioning the wall station!

Connect the wall station to the garage 
door opener head unit using either the 
supplied or pre-existing wires. 

Use the wire that has a mark to connect 
the COMMON (COM) terminals. Make 
sure that you connect the COM terminal 
on the wall station to the COM terminal 
on the garage door opener head unit.

Next, connect the WALL STATION (WS) 
terminal on the wall station to the WALL 
STATION (WALL) terminal on the garage 
door opener head unit. 

Test the Wall Station

Once you have connected the wall station to the 
garage door opener head unit, test if working properly 
by using the wall station to operate the light and door 
by taking the following steps.
•  Plug the garage door opener head unit’s AC power 

cord back into an outlet.

•  Wait a few moments until the LED on the wall station 

comes on.

•  Press the light button to turn the light on and off.
•  Press the cycle door button to operate the door.

If you are unable to operate the garage door using the 
wall station’s buttons, please go to the Troubleshooting 
Guide on page 6.

WIRES TO

WALL STATION

CONNECTING WALL STATION TO OPERATOR

WS

COM

CONNECT WALL STATION WIRES
TO WS AND COM TERMINALS
(

POLARITY IS CRITICAL

)

SETTING THE LIMITS:

- Press and hold EITHER the UP or DOWN button to set LIMIT.
- Press and hold LEARN button.
- Release both buttons. When the light blinks and the alarm
  beeps 2 times, the limit may be set.
- Press and hold the UP (or DOWN) button as needed to move  
 the

door to the desired position.

- Press and release the LEARN button. The light blinks and
  the alarm beeps 2 times to confirm setting.

Repeat the steps above to set the other limit.

CLASS 2 SUPPLY 28 VOLTS

! WARNING:

 Disconnect power before service. See 

instruction manual for proper installation and service of battery.

    COM        WALL       COM       BEAM

UP

DOWN

LEARN

P/N ????????

WALL STATION

(WS)

COMMON
(COM)

Turn light ON & OFF

OPEN & CLOSE door

Wire polarity is critical with the Wi-Fi 

wall station. 

IMPORTANT