Linear HSLG, Installation Manual

HSLG OPERATOR INSTALLATION GUIDE

- 13 -

IMPORTANT NOTES FOR

INSTALLATION OF MASTER/SLAVE APPLICATIONS

When setting up Master/Slave gate operators, it is best to make adjustments and run each operator individually. To do this, 
simply:

a.  Set Dip Switch #4 to proper hand of operation (right-hand or left-hand)

b.  Set Dip Switch #8 as Master (off)

Run each operator making current sensing adjustments as necessary, as indicated on the Control Board Adjustments page 
of this installation guide. When both operators have been adjusted, turn power off, then turn on Dip Switch #8 in the operator 
chosen as the Slave.

The timer to close and radio/single button behavior are set in the Master operator.

The following selections are set individually:
 Current 

Sensing

 Maximum 

Run 

Timer

One-Second Lock Release

 Three-Second 

Pre-Start 

Warning

 Right/Left-Hand 

Selections

SURGE PROTECTOR INSTRUCTIONS

The optional surge protector should be connected 
to any inputs that have an accessory connected to 
it. This includes the 3-button station, so it must be 
connected to 1, 2A and 3 in all cases. The green 
wire connected to ground, which is electrically 
the same as terminal 4. The red wires connect to 
terminals 2A and 24VDC+. This will cause the 
2 amp fuse to blow if this section of the module 
becomes shorted. With any of the other inputs 
connected to the surge protector, if their protection 
line becomes shorted due to a surge over the rating 
of the module, the corresponding LED on the main 
board will remain lit, causing a constant signal to 
the controller. If this is found, please replace the 
entire surge protector with a new unit.

Do not simply unhook the shorted wire, as this 
removes the protection from the circuit that was 
saved by the protector in the fi rst place!