10
ASSEMBLY OF THE GRINDER
Model BG10
Many of the assembly instructions are the same as for
BG6 & BG8 as liosted on pages 8&9 and we will refer
to them below
1) The Wheel Dresser clips into the plastic holder on
top of the grinder as for BG6/BG8.
2) The toolrests are attached to the inside of the
guards with the M8 Hex Head Bolts & Washers (A)
as shown. The gap between the toolrest & grinding
wheel must be adjusted as for BG6/BG8. Rotate the
grinding wheel slowly by hand to ensure it can still run
freely.
3) The eyeshields can be fitted by first unscrewing the
bolt with spring washer & flat washer at position (A)
on the inside guard.
The mounting bracket incorporates a Spark Guard (C)
and should be adjusted to give the correct gap as per
instruction 4) for BG6/BG8 on page 9.
Knob (B) can then be loosened to adjust the plastic
eyeshield as shown and then retightened.
4) Then follow instructions 6), 7) & 8) on page 9 to
fit the coolant tray and to secure the grinder on a
suitable work surface.
A
B
C
A
Model BG8/915
This model has a linishing attachment fully fitted to the
right hand side of the grinder when supplied.
All other parts can be fitted to the grinder and left
hand side as per the instructions for BG8 (pages 8+9)
