Packing List
*
A pair of 200 meters HDMI extender
* 2 (5V 1A) power adapter
* Operating manual
Matters Need Attention
1.Due to the design of the HDMI interface is specific,all equipments with HDMI interface are not allowed using
hot swap operation in principle.In order to protect HDMI as much as possible during the process of installing and
connecting the HDMI extender, please power off the device power supply (DPS) that host and display needs to be
connected to.When the HDMI line and cable are connected
，
plug the HDMI extender and open the power supply
connecting with equipments.
2.There are LED lamp power supply and signal indication on the extender sender and receiver. Only pluging into
electricity, HDMI transmitter and receiver HDMI signal light is red, while only inserting the HDMI line
，
there is no
signal input and indicator; when the HDMI line as a transmitter receiver is connected to the power supply making
the green LED light,it means that HDMI has received signal and power signal, and the equipment can work
normally. If the HDMI line is connected to the power while LED lights are still red, please check that if the host
equipment HDMI signal output is normal and check or replace the HDMI connection line (recommended AWG26
HDMI1.3 standard or above cable, HDMI line length is less than 5 meters).
3. The extension is to be transmitted using a single standard CAT5/5e/6 or more. Cable connection using 568B line
sequence as well as the 8 core cable; non-standard wire is easy to cause problems about poor transmission quality
or transmission distance.
4.The extender adopts the high-definition multimedia interface. Using HDMI to DVI adapter, it can support DVI
digital display interface to transmit DVI signals.Which provides great flexibility in the engineering system.
5. The connecting cable extender should embed wear tube separately. Do not run the lines with 220V or 380V
electric wires or prone to jamming or non screen.
6.The extension has a special grounding device. After the installation is completed, please do well the ground
connection project for both the transmitter and receiver.In this way, it can prevent lightning. Improve the
equipment’s stability and operating.
