10
2 Output section:
The input section of the chassis's rear panel OUTPUT frame, HDMI interface directly
connected to the display unit; Audio can be directly connected to an external sound,
high power audio playback.
3 USB section
USB input section contain the USB1, USB2, USB3, USB4 input port in INPUT box,
which are connected with the respective host computer.
USB output section consists of two USB ports of OUTPUT ,can connect a USB mouse
and keyboard at the same time, to achieve a single set of mouse and keyboard controls
4 mainframe imultaneously.
Connection Description:
1, through the cable four signal source is connected with the input port of the device;
2, by setting so that each window (as shown below Signal 1, Signal 2, Signal 3, Signal 4
four window) display is not the same as the signal source is different (setting mode
refer to the next chapter of the remote control ), do not change display window
position of the signal source;
3, via the USB cable so that the 4computer's USB port respectively, connect with USB1,
USB2, USB3, USB4 of the device; eg :A image of computer is displayed in the window
position of the 1signal,then the computer's USB cable must be connected to the USB1
port of the device, similar to other computer connection.
chapter Five Remote control operation
Properly connect the output signal and display terminal , then you need to properly
connect the input signal source and the device . via remote control, chassis button and
control software to set different display modes, such as quad display, select a signal
full-screen display, the PIP and other functions . This chapter describes how to operate
the equipment via infrared remote control, if you are use our devices for the first time,
configure or settings as follows
