2
Chapter One Installation Notes
For your safety and equipment security, please be sure reading the safety
instructions carefullybefore using the machine.
If you have doubts in the use, please read this manual first. Described in detail in the
body of the device's operation. If you still have questions, please contact us, we will
give you a satisfactory answer as soon as possible.
Specifications subject to release to change without notice, please understand.
When installing, please note the following:
1. power supply:
Please use with protection to single-phase three-wire AC 100-240V power supply,
and ensure that the entire engineering system using the same protected. You can
not use unprotected power, the power cord ground pin can not be destroyed.
2. Power:
When you need tomove equipmentor other work must outage, to shut off all power,
including the power switch, unplug the power plug, so as to ensure the safety of your
equipment.
3. Cable:
The goods can not put pre s s ure on t he powe r s uppl y li ne s, s i gnal l ine s,
communication lines, cable should keep fromtrample or extrusion, to prevent the
risk of leakage or short circuit.
4. Signal cable:
Inserting or pulling the signal line to the device, the device needs outage, so as not to
damage the device. Hot plug caused damage not covered under warranty.
5. Vents:
The outer surface of the device may have openings for heat dissipation, do not block
these openings, in order to avoid heat build-up, the risk of damage to the equipment
or cause fire.