The Chamberlain Group, Inc.
Limit Adjustment Art - CGI
10/7/91 - 5/1/92 - 5/4/92 - 5/26/92
Smart (learn)
Button
Garage Door Opener
(With "Smart" Button)
Indicator
Light
BACK
PANEL
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the Door Control or remote control
transmitter(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
To Add A Remote
1. Press and
hold the remote push button. See
Figure 1.
2. Then press and release the "Smart" (learn) button
on the back panel of the opener in Figure 2. The
opener lights on the panel will
flash once.
3. Release the remote push button.
Now the opener will operate when the remote control
push button is pressed.
If you release the remote control push button
before the opener lights flash, the opener will not
accept the code.
To Erase All Remote Control Codes
• Press and hold the "Smart" button on the opener
panel until the indicator light turns off (about 6
seconds).
All the codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1 - 3 for each remote
control in use.
Your garage door opener receiver and remote control
transmitter have been set at the factory to a matching
code. The door will activate when the remote control
push button is pressed.
Your "Smart" garage door opener will operate with:
• up to four "Smart" remote control transmitters
(with green indicator lights),
• a Keyless Entry System, and
• code switch transmitters with red indicator lights.
Below are instructions for programming your opener
to match any additional remotes you may purchase.
See available accessories on page 34.
L'ouvre-porte de garage
(avec bouton "Smart")
Bouton
"Smart"
Témoin
Télécommande
à un bouton
Bouton-
poussoir
Pile munie
de témoin
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
Single Function Remote Control
Push Button
Battery
Indicator Light
Garage Door Opener
(With "Smart" Button)
END PANEL
"Smart"
Button
Indicator
Light
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
Code programming instructions are also located
on the opener panel.
WARNING
CAUTION
WARNING
Figure 1
Figure 2
Receiver and Remote Control Programming
29
NOTICE: To comply with FCC rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code
setting or replacing the battery. THERE ARE NO OTHER USER
SERVICEABLE PARTS.
To Add the Keyless Entry
We recommend that you program your code before
you install the Keyless Entry. You will not need
assistance, and you can test the reception at the
mounting location before installation.
1. Choose a 4-digit code using numbers from 0 to 9.
You can use a number more than once (for
example, 4, 0, 4, 1). Press the selected code digits
on the keypad.
2. Press and
hold the Enter button while you press
the “Smart” (learn) button on the opener panel. The
indicator light will blink and the door will begin to
move.
3. Release the Enter button. Now the opener has
learned the selected keypad code.
To ensure that your portable remote control codes
were not disturbed while you were programming the
Keyless Entry, test your remotes and reprogram them
if necessary.
To change the code at any time, repeat steps 1-3.
