sensitive to body heat than when outdoor temperatures are warm.
Note:
If the light is not activating during nighttime, a street light, house light or other ambient light could
be affecting activation. Turn the control knob LUX towards position
to increase the daylight level. If
the light is unnecessarily activating during daytime, turn the control knob LUX towards position
to
decrease the daylight level.
Note:
Regularly clean the motion detector to ensure proper functionality(refer to “Cleaning and Care“).
Installation
When selecting the mounting location, pay attention to the following:
Note:
The included mounting material is suitable for solid concrete or masonry construction. Other wall
substrates may require additional fastening materials.
Note:
An electric drill is required
CAUTION! RISK OF INJURY!
Please read the operating instructions for your drill.
CAUTION!
Ensure that you do not damage any electrical cables in the wall or ceiling.
1. To choose the mounting location, make sure the LED light illuminates the desired area, the solar panel
has direct and opulent sunshine and that the product will not be directly exposed to rain.
2. Depending on the mounting height (roughly at 6.5ft) the motion detector has a detection range of max.
39.4ft with a detection angle of 140°.
3. Be sure the motion detector is not illuminated by street lighting at night. This can influence the light.
4. Use the holes on the mounting plate intended for the screws to mark the positions for drilling.
5. Drill two holes on the mounting location, insert wall plugs and fix the mounting plate with screws.
6. Fit the main unit to the mounting plate with screws.
7. Rotate and adjust the solar panel to a position for direct sunlight.
8. Turn the control knob TIME to adjust the duration of the illumination. The lighting duration can be
adjusted from approx. 3 seconds to 7 minutes (+/-10%).
9. Turn the control knob LUX to adjust the daylight level: At the position
, the motion detector will only
react at night. In the position
, the motion detector will respond at daylight levels.
10. After initial installation, the product may need about 2 days for charging under direct and opulent
sunlight, before it can normally operate.
