other ambient light, turn the rotary control LUX towards position
to increase the daylight level. If the
light is activating in daytime which is unnecessary, turn the rotary control LUX towards position
to
decrease the daylight level.
Note:
Regularly clean the motion detector to ensure proper functionality (refer to “Cleaning and Care“).
Installation
When selecting the mounting location, pay attention to the following:
Note:
The included mounting material is suitable for ordinary solid concrete or masonry construction.
Other wall substrates may require other fastening materials. Seek specialist advice if necessary.
Note:
You will need an electric drill.
CAUTION! RISK OF INJURY!
Please read the operating instructions for your drill.
CAUTION!
Ensure that you do not damage any electricity cables in the wall or ceiling.
LED light installation
1. To choose the mounting location, make sure the LED light illuminates the desired area, and the
product will not be exposed to rain.
2. Depending on the mounting height (roughly at 2 m) the motion detector
has a detection range of max.
12m with a detection angle of 140°.
3. Be sure the motion detector is not illuminated by street lighting at night. This can influence the effect.
4. Loosen the two screws on the back of main unit to release the mounting plate.
5. Use the holes on the mounting plate intended for the screws to mark the positions for drilling.
6. Drill two holes on the mounting location, insert wall plugs and fix the mounting plate by screws.
7. Fit the main unit onto the plate by screws.
8. Rotate and adjust the LED light to illuminate the desired area.
9. Turn the rotary control TIME to adjust the duration of the illumination. The lighting duration can be
adjusted from approx. 3 seconds to 7 minutes (+/-10%).
10. Turn the rotary control LUX to adjust the daylight level: At the position
, the motion detector only
reacts at night. In the position
, the motion detector also responds at daylight levels.
Solar panel installation
1. To choose the mounting location, make sure the solar panel has direct and opulent sunshine and the
product will not be exposed to rain.
2. Use the holes on the mounting plate of solar panel intended for the screws to mark the positions for
drilling.
3. Drill four holes on the mounting location, insert wall plugs and fix the solar panel by screws.
4. Rotate and adjust the solar panel to a position for direct sunlight.
5. Connect the solar panel and LED light by plugs on their cables.
10. After initial installation, the product needs about 2 days for charging under direct and opulent sunlight,
then it can normally operate.
