Ce document est la propriété de Linkcom.
Toute reproduction même partielle est strictement interdite
classe
DR
classement
LGISDNeng 6.5
numéro
002.02
date
09/11/04
page
15/22
The second w ay is the time elapsed betw een dialing 2 numbers, w hen the time is too long the
gatew ay will dialed the number.
Setting a type of dialling tone w ith w hich the gate is signalled:
No tone (silence)
Continuous tone 440 HZ (default)
Morses R (preset)
Morses A
The best w ay in numerous configurations in T0 is PTMP instead S0.
PTP or PTMP : Point to point or point to multipoint
Max digit: Numbers dialled before the gateway sends the call without wait.
Wait: How many seconds the gateway will wait before sending the call if the dialled numbers don’t
have the size preset in « max digits ».
Clear: The gateway support CLIP from GSM to ISDN. You can see incoming call numbers on internal
phones. (if PBX support this feature). You can erase first digits of numbers, for example: clear +33 –
country code). Most PBX doesn’t like + (ex +336…) so is better to put 1 to eliminate it.
-Route to ISDN (router) : Route a call to ISDN w hen busy.(Only on “router“ version)
4.7
Save and restore parameters.
You can easily save and restore your values on computer and recall them each time you need.
To save all new values, click on „SAVE TO PC“
Setting protocol on S0 – PTP or
PTMP. In case of PTPM, MSNs are
selected in direct dialling code, while a
direct dialling identifier for PTP.
