Linksys E2000
Appendix D: Regulatory Information
42
Advanced Wireless-N Router
Appendix D: Regulatory Information
FCC Statement
This device complies with Part 15 of the FCC Rules .
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation .
This product has been tested and complies with the
specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules . These limits are designed to provide
reasonable protection against harmful interference in
a residential installation . This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used according to the instructions, may
cause harmful interference to radio communications .
However, there is no guarantee that interference will not
occur in a particular installation . If this equipment does
cause harmful interference to radio or television reception,
which is found by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment or
devices
•
Connect the equipment to an outlet other than the
receiver’s
•
Consult a dealer or an experienced radio/TV technician
for assistance
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate this equipment .
IEEE 802 .11b or 802 .11g operation of this product in the
USA is firmware-limited to channels 1 through 11 .
The device for the band 5150-5250 MHz is only for indoor
usage to reduce the potential for harmful interference to
co-channel mobile satellite systems .
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment . This
equipment should be installed and operated with
minimum distance 20 cm between the radiator and your
body .
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter .
Safety Notices
WARNING:
Do not use this product near water,
for example, in a wet basement or near a
swimming pool .
WARNING:
Avoid using this product during an
electrical storm . There may be a remote risk of
electric shock from lightning .
WARNING:
This product contains lead, known
to the State of California to cause cancer, and
birth defects or other reproductive harm . Wash
hands after handling .
Caution: To reduce the risk of fire, use only No .26 AWG or
larger telecommunication line cord .
Industry Canada Statement
This Class B digital apparatus complies with Canadian
ICES-003 and RSS210 .
Operation is subject to the following two conditions:
1 . This device may not cause interference and
2 . This device must accept any interference, including
interference that may cause undesired operation of
the device .
To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the EIRP
is not more than required for successful communication .
Industry Canada Radiation Exposure
Statement
This equipment complies with IC radiation exposure limits
set forth for an uncontrolled environment . This equipment
should be installed and operated with minimum distance
20 cm between the radiator & your body .
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter .
Restrictions in the 5 GHz Band
1 . The device for the band 5150-5250 MHz is only
for indoor usage to reduce potential for harmful
interference to co-channel mobile satellite systems .
2 . This device has been designed to operate with an
antenna having a maximum gain of 4 dBi and 3 .5 dBi
at 2 .4 GHz and 5 GHz respectively . Antenna having
a higher gain is strictly prohibited per regulations of
Industry Canada . The required antenna impedance is
50 ohms .
