Linksys Voice System Administration Guide
147
Remote Provisioning Features
Figure A-5 Unprovisioned Client Station Acquiring a Configuration Profile
To add a new IP phone to the SPA9000, connect the IP phone to the QoS switch to which the
SPA9000 is connected and power on the unit.
To add a previously-used IP phone to the SPA9000, perform the following steps:
1.
Upgrade the IP phone with SPA9000-compatible firmware.
2.
Factory reset the unit.
3.
Power cycle the unit.
4.
Connect the unit to the switch.
The SPA9000 provisions only the necessary parameters to the client stations. It assumes the rest
of the parameters have appropriate values, which are either the default values or manually
configured values. For example, the SPA9000 provisions only Extension 1 on the client stations.
Access the administration web server using the Administrator account to manually configure
other extensions on specific client stations.
Manual Client Configuration
The client stations can also be manually configured with the contents of the profile served by
the SPA9000.
The following XML file is served by the SPA9000 when a client station requests /spa$PSN.cfg
<flat-profile>
<Resync_Periodic>1</Resync_Periodic>
<Profile_Rule>tftp://spa-9000-ip-address:69/cfg/init_$MA.xml</Profile_Rule>
</flat-profile>
The following XML file is served by the SPA9000 when client station requests /cfg/init_$MA.xml:
<flat-profile>
<User_ID_1_>next-available-user-id</User_ID_1_>
<Extension_1_>1</Extension_1_>
DHCP
Option 66?
Look For
Config Server
Request
/spa$PSN.cfg
Request
/cfg/init_$MA.xml
Request
/cfg/generic.xml
No
Yes
Summary of Contents for Linksys SPA9000
Page 245: ...Linksys Voice System Administration Guide 243 ...
Page 246: ...080322NC LB ...