Linksys Voice System Administration Guide
35
Using the Interactive Voice Response Unit
Basic Administration of the SPA9000
Table 2-1 IVR Options
IVR Action
IVR Menu
Choice
Parameter(s)
Notes
Enter IVR Menu
* * * *
None
Ignore SIT or other tones until
you hear, “Linksys configuration
menu. Please enter option
followed by the pound key or
hang-up to exit.”
Exit IVR Menu
3948
None
Check DHCP
100
None
The IVR spells "S,T,A,T,I,C" if the
setting is for a static IP address or
"D,H,C,P" for a DHCP IP address.
Enable/Disable
DHCP
101
Enter 0 to enable
Enter 1 to disable
Requires password
Check WAN IP
Address
110
None
IVR announces the current IP
address of the WAN port.
Set Static IP
Address
111
Enter IP address using
numbers on the
telephone key pad. Use
the * (star) key when
entering a decimal
point.
DHCP must be “Disabled,”
otherwise you hear, “Invalid
Option,” if you try to set this
value. Hang up the phone after
setting the IP address. The
SPA9000 reboots and the new
address takes effect. Do not
attempt to use IVR option 110
immediately after changing the
IP address. The old IP address is
reported until the SPA9000
reboots.
Requires password
Check Network
Mask
120
None
IVR announces the current
network mask of SPA.
Set Network Mask
121
Enter value using
numbers on the
telephone key pad. Use
the * (star) key when
entering a decimal
point.
DHCP must be “Disabled,”
otherwise you hear, “Invalid
Option,” if you try to set this
value.
Requires password
Check Static
Gateway IP
Address
130
None
IVR announces the current
gateway IP address of SPA.
Summary of Contents for Linksys SPA9000
Page 245: ...Linksys Voice System Administration Guide 243 ...
Page 246: ...080322NC LB ...
