Linksys ATA Administration Guide
114
Regional page
Voice tab > Regional page >
Ring and Call Waiting Tone Spec section
IMPORTANT:
Ring and Call Waiting tones don’t work the same way on all phones. When setting
ring tones, consider the following recommendations:
1. Begin with the default Ring Waveform, Ring Frequency, and Ring Voltage.
2. If your ring cadence doesn’t sound right, or your phone doesn’t ring, change your Ring
Waveform, Ring Frequency, and Ring Voltage to the following:
a. Ring Waveform: Sinusoid
b. Ring Frequency: 25
c. Ring Voltage: 80V
Voice tab > Regional page >
Control Timer Values (sec) section
Ring6 Name
Name in an INVITE’s Alert-Info Header to pick distinctive ring/CWT 6 for the
inbound call.
The default is
Bellcore-r6
.
Ring7 Name
Name in an INVITE’s Alert-Info Header to pick distinctive ring/CWT 7 for the
inbound call.
The default is
Bellcore-r7
.
Ring8 Name
Name in an INVITE’s Alert-Info Header to pick distinctive ring/CWT 8 for the
inbound call.
The default is
Bellcore-r8
.
Ring9 Name
Name in an INVITE’s Alert-Info Header to pick distinctive ring/CWT 9 for the
inbound call. This field is for the SPA2102 only.
The default is
Bellcore-r9
.
Field
Description
Hook Flash Timer Min
Minimum on-hook time before off-hook qualifies as hook-flash. Less than
this the on-hook event is ignored. Range: 0.1–0.4 seconds.
The default is
0.1
.
Hook Flash Timer Max
Maximum on-hook time before off-hook qualifies as hook-flash. More than
this the on-hook event is treated as on-hook (no hook-flash event). Range:
0.4–1.6 seconds.
The default is
0.9
.
Callee On Hook Delay
Phone must be on-hook for at this time in sec before the ATA device will tear
down the current inbound call. It does not apply to outbound calls. Range:
0–255 seconds.
The default is
0
.
Reorder Delay
Delay after far end hangs up before reorder tone is played. 0 = plays
immediately, inf = never plays. Range: 0–255 seconds.
The default is
5
.
