SPA400 Internet Telephony Gateway with 4 FXO Ports
Administration and Configuration Guide v1.0
SPA400 Internet Telephony Gateway with 4 FXO Ports – Administration and Configuration Guide v1.0
© 2006 Linksys
4
Click Save Settings at the bottom of the page and then the Restart button on the
SPA400 configuration utility. The SPA400 device will reboot. Continue to
Configuring the SPA9000 to register the SPA400
.
Configuring the SPA9000 to register the SPA400
There are three setting that must be configured on the SPA9000 to complete the
SPA400 installation. Select the appropriate Line tab from the SPA9000 configuration
utility (Line 1 is used in the example in Figure 2). From this configuration page, the
following fields must match the settings entered in the SPA400 configuration:
SIP Settings: SIP Port =
5060
(
SPA400 Port)
Subscriber Information: User ID =
SPA9000
(
SPA400 User ID)
Proxy and Registration: Proxy =
192.168.15.107
(
SPA400 IP Address)
Click the Submit All Changes button on the SPA9000 configuration utility. The
SPA9000 device will reboot.
The SPA9000 is now configured to access the PSTN allowing calls to be routed to
and from the analog line(s) connected to the SPA400.
