7
Chapter 3: Getting to Know the Wireless-G Access Point
The Back Panel
Wireless-G Access Point
The Back Panel
The Access Point's Ethernet network and power ports, as well as the Reset button, are located on the back panel.
LAN Port
The Ethernet network port connects to an Ethernet network device, such as a switch or router.
Reset Button
There are two ways to reset the Access Point's factory defaults. Either press the
Reset
button,
for approximately ten seconds, or use the
Administration - Factory Defaults
screen of the
Access Point's Web-based Utility.
Power Port
The Power port connects to the Access Point’s power adapter.
Figure 3-2: Back Panel
port:
the connection point on a computer or
networking device used for plugging in
cables or adapters
IMPORTANT:
Resetting the Access Point will erase all of your settings
(including wireless security, IP address, and power output) and replace them
with the factory defaults. Do not reset the Access Point if you want to retain
these settings.
