background image

Warning

-  Please dispose of lifeless battery under guidance.

-  Recycle your device.

-  Replacement of a battery with an incorrect type that can defeat a 

   safeguard (for example,in the case of some lithium battery types);

-  Disposal of a battery into fire or a hot oven, or mechanically crushing or 

   cutting of a battery, that can result in an explosion;

-  Leaving a battery in an extremely high temperature surrounding 

   environment that can result in an explosion or the leakage of flammable 

   liquid or gas; 

-  A battery subjected to extremely low air pressure that may result in an 

   explosion or the leakage of flammable liquid or gas.

Used below 35

 in the state of charge

Regulatory Compliance

Federal Communication Commission (FCC) — USA

This device complies with Part 15 of FCC Rules. Operation is subject to the 

following two conditions:(1) this device may not cause harmful interference, 

and (2) this device

must accept any interference received; including interference that may cause 

undesired operation.

This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against harmful interference in

residential installation. 

This equipment generates, uses, and can radiate radio frequency energy, 

and if it is not installed and used in accordance with the instruction manual,

it may cause harmful interference to radio communications. However, there is 

interference will not occur in a particular installation.

 If this equipment does cause harmful interference 

which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the 

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which 

   the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

   Warning: Any changes or modifications to this unit not expressly approved 

   by the party responsible for compliance could void the user’s authority to 

   operate the equipment.

FCC Radiation Exposure Statement:  

The device has been tested and comply with FCC SAR limits. And keep the 

device minimum 5mm from the body when normal use.

This equipment complies with Part 68 of the FCC rules and the requirements 

adopted by the ACTA. On the bottom of this equipment is a label that contains, 

among other information, a product identifier in the format 

US: 3I1IPNANW611W. 

If requested, this number must be provided to the telephone co mpany.

and used in accordance with the instruction manual, it may cause harmful 

no guarantee that 

to radio or television reception, 

Summary of Contents for W611W










Reviews: