LinMot Linear-Rotary Motors
Lubrication and assembling
Lubricate the grooves (6) with 2-3 g (0.1 oz.) LU02. Lubricate the bore of the stators (3) with about 2-3 g (=0.1 oz.)
lubricant LU02. There should only be a slight film of lubricant. Do not over lubricate! Lubricate the slider (5) with a
soft fabric or manually. 4 g of lubricant per meter slider is enough to create a film of lubricant on the surface of the
sliders. (4 g (0.14 oz.) is about ½ of a hazelnut). Do not over lubricate! Especially in higher operating temperatures,
over lubrication can lead to a gumming of the lubricant. (In such a situation the motor must be cleaned completely.)
If wipers are used then the inner side of the seals of the wipers must be lubricated as well. Do not lubricate outside
of the wipers!
Assembling: move the mounting ring (7) adjusted into the stator (3). Make sure that the slider (5) is centered with a
cardboard or wood wrapping because of the magnetic attraction to the outside of the stator (3). Then move the
stator (3) over the slider (5). Tighten the fastening screws 2a and 2b simultaneously to make sure the slider, stator,
and rotary motor are concentric. If existing then tighten screw 2c lightly in the same manner. Use bolt lock
(medium).
Lubric
ant
The lubricant reduces the friction between the chromium-nickel steel surface of the slider and the reinforced plastic
plain bearing.
LinMot
®
Lubricant LU02
Art. No. 0150-1953 (8g)
LinMot
®
Lubricant LU02
Art. No. 0150-1954 (50g)
LinMot
®
Lubricant LU02
Art. No. 0150-1955 (1000g)
LinMot®
LU02 Lubricant corresponds to KLÜBERSYNTH UH1 14-31 which was developed for the food processing industry.
Cleaning Agent
The following Cleaning Agent spray is recommended for LinMot Stators and Sliders:
LinMot
®
Spray LU06-250
(250ml)
Art. No. 0150-2394
LinMot®
LU06 Lubricant corresponds to KLÜBERSYNTH NH1 4—2 which was developed for the food processing industry
.
Storage / transport
·Sliders are to be stored and transported only in the plastic containers (with cardboard inlay) provided for this, or already fitted
in
LinMot
®
motors
and secured.
·Maximum storage temperature: 70 °C
NTI AG/ LinMot
0185-0015-E_2V94_IG_Linear_Rotary_Motors_PR01.odt
74/79
