Table of user options
The following table shows the user options that are available, briefly
describes them and shows the available settings for each. Default
settings are shown in bold (and are marked with a ‘*’ on the front
panel display).
ENGLISH
16
AKURATE CD
Display
Brightness
Sleep Display
Delay
Front Panel IR
(infrared)
Commands
Pass IR to
Remote Out
Pass Remote
In To Out
Allows adjustment to the
brightness of the front panel
display. When set to AUTO the
unit will select a brightness level
based on the ambient light level
in the room (the greater the
ambient light level, the brighter
the display will be).
Sets the number of seconds that
the unit is inactive for before the
sleep display (three dots) is
shown on the front panel.
If set to ACCEPTED, unit will
respond to commands received
via the IR receiver on the front
panel.
If set to ENABLED, passes
commands received via the IR
receiver on the front panel to
REMOTE OUT. Will function even
if ‘Front Panel IR Commands’ is
set to IGNORED.
If set to ENABLED, passes RC5
commands received at REMOTE
IN to REMOTE OUT.
A
AU
UT
TO
O
2% to 100%
(non-linear)
O
OF
FF
F
0m 10s to 5m 00s
(in 10 sec steps)
A
AC
CC
CE
EP
PT
TE
ED
D
IGNORED
E
EN
NA
AB
BL
LE
ED
D
DISABLED
E
EN
NA
AB
BL
LE
ED
D
DISABLED
O
Op
pttiio
on
n
D
De
es
sc
crriip
pttiio
on
n
S
Se
ettttiin
ng
gs
s
SPDIF Out
LPCM Output
(Digital outputs
only)
If you are not using the AKURATE
CD’s digital audio outputs, set to
OFF.
If any of the AKURATE CD’s
digital outputs are connected to a
Linn AKURATE KONTROL
pre-amplifier, other external audio
decoder or other device, set to
RAW.
If you are recording to an external
digital source (e.g. DAT player),
set to LtRt PCM.
If any of the AKURATE CD’s
digital outputs are connected to a
Linn AKURATE KONTROL pre-
amplifier, or any other device
which accepts a sampling rate of
96 kHz, set to LPCM 96 k.
If the external device does not
accept a sampling rate of 96 kHz,
set to LPCM 48 k.
Notes:
Even when set to LPCM 96 k,
some discs will only output at the
lower rate of 48 kHz.
Audio signals from SACDs and
DVD-Audios are output as
analogue only. There is no output
for these disc types from the
digital connectors.
R
RA
AW
W
LtRt PCM
OFF
L
LP
PC
CM
M 9
96
6k
k
LPCM 48k
O
Op
pttiio
on
n
D
De
es
sc
crriip
pttiio
on
n
S
Se
ettttiin
ng
gs
s
AKURATE cd english 15/5/07 08:42 Page 24
Summary of Contents for AKURATE CD Player
