17
DISPLAY until “P--A” appears. Then release DISPLAY and the display will
show “P” followed by the number of program slots used. Enter the additional
tracks using SKIP and DISPLAY as described previously. Press STOP
o
when
you have finished adding tracks.
TO PLAY THE SELECTION YOU HAVE MADE
press PLAY
2
.
TO PREPARE TO PLAY THE SELECTION YOU HAVE MADE
press
PAUSE
p
. This is useful when you are making a tape. When you are ready to
listen or record, press PAUSE
p
again or PLAY
2
to start your selection.
TO ADD MORE TRACKS TO THE PROGRAM
after it is playing press
STOP
o
. You can now check or add to the program as described above.
TO CANCEL THE PROGRAM
press OPEN. The program is now cleared.
TO OMIT A SET OF TRACKS
make sure the disc is loaded but not playing.
Press and hold the button marked DISPLAY for about 4 seconds until the
display shows
P - - b
which indicates that programming mode b has been entered. Release
DISPLAY, and the display will show
P-00
indicating that the KARIK is ready for you to enter to your selection. Enter
tracks in the same way as for programming mode A. When you now play the
disc the tracks you have entered will not be played.
NOTES ON PROGRAM MODE
While the KARIK is playing a stored program
the A-B REPEAT function is disabled and SKIP
i
or
u
SKIP will skip to the
next or previous track in the programmed sequence. SEARCH
y
will search
through the current track, and then into the next track in numerical, rather
than program, sequence. So, you can use SEARCH
y
to break out of the
stored program. If you do so though, the program will resume at the end of the
track you used SEARCH
y
to get into.
