5
ELECTRONIC SPECIFICATIONS
Input impedance:
2000 ohms
Maximum source impedance:
600 ohms
Output impedance:
200 ohms
Minimum load impedance:
600 ohms
Nominal input level:
1 Volt rms
Gain on each band:
adjustable from OdB to +12dB in 0.25dB steps
Distortion:
less than 0.1%
Connections:
3 pin male XLR
Pin 1: 0 Volts
Pin 2: Left
Pin 3: Right
ACOUSTIC SPECIFICATIONS
(When used with Linn Isobarik loudspeakers)
Crossover frequencies:
bass to middle 200Hz second order
middle to high 2700Hz fourth order
Achievable near field frequency response:
50Hz to 20kHz +/- 2dB
Achievable near field phase response linearity. 50HZ to 20kHz +/- 45 degrees
Note:
when used with Linn LK1 preamp all speaker phases should be reversed at the power
amp to maintain absolute phase due to phase inversion in the LK1.
GENERAL
Mains supply:
100V, 115V, 200V, 220V, 240V – 50/60Hz
(one voltage per mains module)
Power Consumption:
20 Watts
Dimensions:
320mm W x 265mm D x 75mm H
Weight:
4kg
