'
PREPARATION:
SELECT A WORK SURFACE. WE RECOMMEND A TABLE TOP. PLEASE PROTECT IT VERY WELL,
INCLUDING THE EDGES TO PREVENT ANY DAMAGES; YOU MAY USE A BLANKET AND THE
CARDBOARD FROM THE STOOL BOX
．
YOU WILL NEED TO USE YOUR OWN PHILLIPS SCREWDRIVER WITH #2 SIZE HEAD
．
STEP-1: CONNECT SEAT-1A TO BACK-1B AS SHOWN IN FIGURE-1
FIGURE-1
1.1
POSITION BACK-1B ON THE WORK SURFACE AS SHOWN IN FIGURE-1.
1.2
LOOK FOR TWO WOODEN DOWELS OUTSIDE SEAT-1A; INSERT THEM INTO THE
CORRESPONDING HOLES IN THE RAIL OF BACK-1B.
1.3
INSERT ONE SPRING WASHER-J, THEN ONE FLAT WASHER-I OVER ONE BACK LEG
BOLT-G; INSERT THE BOLT-G THROUGH ANY OF THE FOUR HOLES IN THE CORNER
BRACKETS ADJACENT TO THE BACK LEGS; IF NECESSARY, MOVE THE BOLT-G AROUND TO
FIND THE HOLE IN THE BACK LEG. TIGHTEN BY HAND.
1.4
REPEAT PROCEDURE 1.3 TO INSTALL THE REMAINING THREE SETS G+J+I.
1.5
REPEAT PROCEDURE 1.4 TO INSTALL TWO SHORT BOLTS WITH HARDWARE F+J+I TO
SECURE SEAT–1A TO BACK-1B.
PAGE 3
