33
System
The System page is used for software update or reset the software to factory default if needed.
Load/Reboot System Page
Click
System
–
Load/reboot System
, from here you can upload the software file if you need to update the software on your SERVER,
or reset the device to factory default if needed.
Reset to Factory Default
There are two ways to reset the SERVER to its factory defaults.
1.
Reset through the hardware: For some reasons, such as forgetting password, you can reset the SERVER to factory default in
order to use the default login credentials (admin/admin). To reset to factory default from the hardware, first to push the
RESET
button, the
RED
LED should be blinking and the
GREEN
LED is on. While in this state (called Bootload state) press and
hold the
RELOAD
(DFLT) button (about 10-15seconds) until the RED LED comes on steady (blinks at 1 second rate). To locate
the RESET/RELOAD buttons, please check
section in this manual.
2.
There is an equivalent RESET DEFAULTS function in the web browser at
System/ Load/Reboot System
page. Check the
Restore Default Values
box, then click the
Boot Mode
button, your device will be reset to factory default once the RED LED
come back to normal (blinks at 1 second rate).
Update Software
Your SERVER comes with the latest version of software when it leaves the factory. When a new software version is available, you can
download it from our website Download page, then upload it to your SERVER from the System
–
Load/Reboot System page. Check
the
Update Software
box, then click Boot Mode, a new window will popup with the upload interface. Click the Choose File button to
select the software you just downloaded from our website, then click Upload. Once the software is successfully uploaded, you will
Summary of Contents for iTrixx-Ultra 300
Page 2: ...2 ...