9.2 Safety Instructions
•
Please follow all safety instructions including the directions for the connected equipment.
•
Read this instruction manual carefully. It will enable you to best use the
M50PCI
stepping
motor card
and prevent problems and damage.
•
Always keep this instruction manual handy.
•
When installing the
M50PCI stepping motor card
in a PC, be sure to observe the rules
and regulations in force.
•
Make sure that if you connect an external power supply, the maximum voltage of 48 volts
DC cannot be exceeded.
•
Never expose the
M50PCI
stepping motor card
to direct sunlight, high humidity, dirt or
extreme temperatures.
•
The
M50PCI
stepping motor card
may only be used in dry rooms that do not have any
risk posed by an explosive atmosphere.
•
It is prohibited to use the
M50PCI
stepping motor card
outdoors.
•
Ensure that the
M50PCI
stepping motor card
is sufficiently ventilated at all times.
•
Check that the cable has the correct current-carrying capacity and that the appropriate
connectors are correctly wired and attached; to avoid wire breakage or a cable break,
install all cables so that they cannot cause any accidents.
•
Unplug or plug in the cables only after the PC has been shut down and the power turned
off.
•
The
M50PCI
stepping motor card
may only be operated in a range of 0-40°C and up to
80% relative humidity.
•
Do not store the
M50PCI
stepping motor card
below 0°C (32°F) or above 70°C (158°F)
and only up to 80% relative humidity.
•
Using the card in equipment on people, e.g. controlling a surgical robot, is strictly
forbidden.
•
The
M50PCI
Commander
stepping motor card
is not a toy and may not be used as such.
These instructions are a component of the
M50PCI
stepping motor card
and must be kept handy. If this card is given or sold to other persons,
these instructions as a component of the equipment must also be given to
these persons.
402310 22 M50.PCI
