12.1.1 Installation Steps:
12.1.1 Installation Steps:
Open the housing of your computer.
Open the housing of your computer.
Select an available PCI port and remove the cover to
expose the socket.
Select an available PCI port and remove the cover to
expose the socket.
intern
Position the
red jumper
(JP1) of M50.PCI according to the
type of power supply you wish to use. 'Intern' stands for
powering the card by your PC power supply unit and
'extern' means that you will be using an external power
source.
Position the
red jumper
(JP1) of M50.PCI according to the
type of power supply you wish to use. 'Intern' stands for
powering the card by your PC power supply unit and
'extern' means that you will be using an external power
source.
(bis 48V)
extern
(12V )
Plug an available hard disk connector into the socket on the
rear side of the
M50PCI stepping motor card
!
(Only if you are using internal power supply!)
Plug an available hard disk connector into the socket on the
rear side of the
M50PCI stepping motor card
!
(Only if you are using internal power supply!)
M50.PCI 27 40
2310
