22
Counter
When pulse counter reaches a specific value. This only works when DI works
as counter mode.
Channel/4-20m
A/0-10V/PT100
When the value reaches any threshold.
Is continuedfor:
the analog value should last for some time.
Set lockout time:
after the lockout time,
IOT-C300-LORA
device will detect
if analog value matches the condition. 0 means this IF condition will only
be detected once.
Note:
for
IOT-C300
cellular version, if this Modbus channel quantity is more
than 1, this condition will only judge the first value.
Received a
message
When
IOT-C300-LORA
device receive a specific message from
server.
The Device
Restarts
Reboot the device.
Received a D2D
control
command
This only works with
IOT-C300-LORA
version and the LoRa D2D feature
is enabled. See details on
chapter 4.5
.
The signal
strength is weak
When
IOT-C300-LORA
cellular signal is lower than 10 asu, this only
works with
IOT-300
cellular version.
3. Set THEN action according to your request. You can add at most 3 actions in one command.
Action
Description
Send a custom
message
Send a custom message to the server.
Output Trigger
DO can be set to normally open/normallyclosed/change status.
DelayTime:
this action will trigger after a specific time;
Duration:
the output status will last for a specific time, 0 means permanent.
Restart the Device
Reboot the device.
Send a D2Dcontrol
command
This only works with
IOT-C300-LORA
version and the LoRa D2D feature
is enabled. See details on
chapter 4.5
.
Send a Modbus
command via
RS485 interface
This only works with
IOT-C300-LORA
version and the LoRa D2D feature
is enabled. See details on
chapter 4.5
.
Send a device
status message
This only works with
IOT-C300
cellular version and the SMS Report feature
is enabled.
