3. Basic Configuration
In order to protect the security of sensor, password validation is required when configuring via
unused phone . Default password is 123456.
3.1 Configuration via Smartphone APP
Preparation:
Smartphone (NFC supported)
Toolbox APP: download and install from Google Play or Apple Store.
3.1.1 Read/Write Configuration via NFC
1. Enable NFC on the smartphone and open“Toolbox”APP.
2. Attach the smartphone with NFC area to the device to read basic information.
Note: Ensure the location of smartphone NFC area and it is recommended to take off phone case
before using NFC.
3. Change the on/off status or parameters, then attach the smartphone with NFC area to the device
until the APP shows a successful prompt.
4. Go to“Device > Status” to tap“Read”and attach the smartphone with NFC area to the device to
read real-time data of sensor.
