Shenzhen Linshang Technology Co., Ltd.
2020-10-26 Page 5 of 8
2. ON/OFF
1)
In POWER OFF state, short press “POWER” button to power on the meter. After turning on the meter,
the meter displays the calibration coefficient, version number, serial number, etc. and then enters the
last measurement interface (STOP interface). As shown below:
In the “STOP” interface, long press the “POWER” button to power off the meter.
2)
In the “STOP” interface, the meter will automatically power off in 3 minutes without any operation.
3)
In the automatic trigger measurement “Ready” state, the longest waiting time is 50 minutes. If the
measurement cannot be triggered within 50 minutes, it will automatically turn off.
3. Measurement
In the measurement mode, three operation states exist:
READY:
Ready state; in the auto trigger mode, this means the meter is waiting for triggering to begin a
measurement.
RUN:
Measuring state; this means the meter is measuring data.
STOP:
Measurement is over.
In measurement interface:
M:
Manual measurement mode
A:
Auto measurement mode
1) Manual measurement mode: in the STOP interface. Short press the "POWER" button and then short
press the "SELECT" button to confirm the new measurement, clear the historical data (display "-----"),
