If you need help or have any questions, contact us at
1-877-732-4980
or
support@linxup.com
JBUS Installation
Installing Your JBUS Device
You will need your device and the cord. Begin with the ignition off.
Connect the cord to the device, then plug the device into the J-Bus port. Use the enclosed zip tie to securely
fasten the device within your vehicle
1
2
3
Turn on the ignition, and verify green and orange lights on the device.
Your vehicle must be outside and not in a covered area so that it will receive GPS signal. When working
properly, the orange and green lights will be on. You should see your vehicle’s location on the map (may
take up to two hours).
