Running your locomotive in the TrainMaster Command environment
Press
AUX2
to turn on
your A-unit’s headlights or
B-unit’s back-up lights.
Activates keypad.
Air-release sound.
Press
HALT
to shut down
all
PowerMaster
electrical output on
your railroad. Stops
all
Command-equipped Lionels in
operation.
Turn the
THROTTLE
to the right to
accelerate, left to
decelerate (powered
unit).
Y
our Command-equipped
locomotives come factory-
programmed with an ID# of “1”. To
get your locomotives in action, set
PowerMasters to CMD or set all power
supplies on full (no more than
19 volts). Press
ENG
and
1
on your
CAB-1 Remote Controller. Turn the
throttle or press any command button;
your locomotives are ready for
Command operations.
Address Locomotive #1
Set PowerMaster to CMD or traditional
power supplies to full throttle (no more
than 19 volts)
Press ENG
Press 1 (the ID#)
Throttle up/press any command button
Example
CAB-1 commands for your locomotives
Press
WSTL/HRN
to
activate the locomotive’s
horn, release it to
discontinue (non-powered unit).
MultiHorn diesel horn
sound.
Press
DIR
—the
locomotive decelerates to a
complete stop; turn the throttle up,
and the locomotive will accelerate
in the opposite direction. There is
no neutral state (powered unit).
Diesel air-release sound.
Press
BELL
once to acti-
vate the bell, again to
discontinue (non-powered
unit).
Diesel mechanical bell
sound.
Press and hold
BOOST
for
extra power. Release
BOOST
and return to the
locomotive’s previous speed
(powered unit).
Press and hold
BRAKE
to
slow down or stop. Release
BRAKE
and return to the previous
speed (powered unit).
Squealing
brake sounds.
Front coupler releases
(powered unit).
Coupler release
sounds.
Rear coupler releases
(non-powered unit).
Coupler release
sounds.
TrainMaster Command operations
SET
L
M
H
Beneath this panel
Use
HALT
only in
emergency
situations.
Note!
11
RailSounds effects are in bold italic.
The sounds are inside the non-powered unit.
