Replacing the caboose’s interior lamp
T
he interior of your caboose is
illuminated by one lamp, Lionel
part no. 600-8352-311. During the
course of normal operations, this
lamp may require replacement.
Replacement lamps are available at
your authorized Lionel Service
Center or from Lionel Service in
Chesterfield, MI.
1. Remove the two screws from the
ends of the car.
2. Lift the body straight up and off
the frame.
3. Gently press down and rotate the expired lamp, then pull it out of the socket.
4. Press the replacement lamp into the socket, rotating it until it locks into place.
5. Reinstall the body, making sure that the ladders are in place before tightening the screws.
Figure 11. Caboose lamp replacement
Operating your Barrel Car
T
he Barrel Car can be operated on any Remote-
Control Track section.
1. Load all six barrels into the center channel of
the car.
2. Position one truck on a Remote-Control Track
(available separately) section so that its
sliding contact shoe is on the right-hand side
of the track.
Positioning BOTH trucks on the Remote-Control Track section before operating
the car will cause a short. Only one truck should be positioned on this section.
3. Press UNLOAD on the Remote-Control Track section’s controller, and a barrel will be
unloaded.
Do not hold down the UNLOAD button for too long, or the magnetic coil may
overheat and damage your layout.
23
Caution!
Caution!
Rolling stock operations
Figure 10. Barrel car
