Y
our Pylon is illuminated by one 18-volt lamp. During the course of normal operations,
this lamp may require replacement. Follow these steps to replace the lamp with Lionel
part no. 612-3011-311.
1. Lift the support arm out of the tubes at the top of the pylon. Also, remove any screws
securing the base to your layout.
2. Remove the four base screws from the underside of the base with a small Phillips-head
screwdriver and lift away the roof and pylon tower. Refer to Figure 5 on page 10 for the
location of the screws.
3. Locate the lamp in its small, black fixture. Carefully pull the lamp straight up and out of
the socket. Refer to the Figure 6 on page 11 for the lamp location.
4. Install the replacement lamp. Line up the bottom of the bulb with the socket and carefully
push the lamp down into place.
5. Reassemble the Pylon, following these steps in reverse order.
Replacing the lamp in your Dumbo Pylon
9
