16
Odyssey System operations
U
se your CAB-1 Remote Controller to turn the Odyssey System speed control on or off.
The
position of the Odyssey switch (see Figure 2 on page 5) is the Odyssey
System default setting when you power up the locomotive.
You may override the
default with the following commands. The override settings will be cleared and the default
settings will be restored when the locomotive is powered down.
Odyssey System Command operation
Turns off Odyssey System speed control.
When you press
7
, you will activate a TowerCom announcement. This has no
impact on the Odyssey System function.
Turns on Odyssey System speed control.
Do not wait longer than two or three seconds between pushing the buttons in each sequence.
If the command is not accepted, repeat the sequence.
The locomotive must
not
be in motion while enabling or disabling the Odyssey
System speed control.
Note!
Note!
When you press
9
, you will activate the Steam blow-off sound and turn on the
smoke unit (if it was off). This has no impact on the Odyssey System.
Note!
