Operating your Pirate Ship with TrainMaster Command Control
W
ire your accessory with an SC-2 Switch and Accessory Controller (available separately,
6-22980) or the Accessory Switch Controller (available separately, 6-14182). Refer to
these manuals for additional information.
Be sure that the ON/OFF switch is in the ON position. Refer to Figure 2 on page 4 for
the location of that switch.
SC-2 wiring and operation
Three wires (not included) are needed to connect your Pirate Ship to the SC-2 and a separate
accessory transformer. We recommend using 22 gauge wire.
1. Attach one wire to the transformer Common/Ground/U terminal and
connect it to the accessory COMM (common) position on the SC-2.
2. Connect one of the Pirate Ship terminals to the accessory ON/OFF toggle
position on the SC-2.
3. Finally, connect the remaining Pirate Ship terminal to the transformer
Power/A terminal.
Use the AUX2 button on your CAB-1 Remote Controller to toggle the Pirate Ship ON and OFF.
5
ACC2
ACC2
ACC1
ACC1
POWER
SUPPLY
Common/Ground/U
Common/Ground/U
Power/A
Power/A
Figure 3. SC-2 connections
Note!
