Operating and Maintaining your Passenger Cars
40
StationSounds Diner
1. Loosen the four front and rear vestibule screws from the bottom of the frame, then pull the
end caps off the car body. Refer to Figure 18 on page 41 for the locations of the screws and
the vestibule.
2. Reach into the car and unplug the wire connector. The wire connector is found towards the
end of the car with the smaller windows. As illustrated in Figure 13 on page 36, be sure to
pull on the white connector housing, not the wires.
3. Carefully slide the light panel out of the opposite end of the car.
4. Gently pull the expired lamp straight out of the socket, then replace it with Lionel part
no. 630-9134-300. Make sure that the replacement lamp is positioned like the original.
Refer to Figure 14 on page 36.
5. Reassemble the car by following these steps in reverse order.
Replacing the lamps (continued)
Summary of Contents for Union Pacific ALCo PA
Page 47: ...Notes 47 ...
