Instructions
Stump cutter SFB 50
15 - 20
150130-04-EN BA SFB 50 / 22.03.2019
12. Maintenance
Steps to be carried out in order to maintain the machine in good
working condition:
•
The bearing housing of the Stump Cutter is filled with liquid gear
grease and is usually maintenance-free. In case of grease
leaking out or after external force being applied to it, a check
must be carried out.
The filler neck is at the underside of the housing. To check it, the
unit must be tilted by 90 degrees, filling level to lower edge of the
charging hole.
Lubricant to be used:
Liquid gear grease based on sodium bicarbonate, type GP00
Filling amount: 0.2 kg
•
Check the plastic apron and replace it, if necessary!
•
Check whether all screws, especially those of the cutting blades,
are firmly tightened. Replace damaged screws immediately.
(See chapter "11. Replacement of the cutting blades").
•
Attention!
Only use original screws.
Filler neck
Summary of Contents for SFB 50
Page 20: ...20 20 Design mail bauer ib com...
