Rev: 08.29.2014
Page 5
Bauer NE Lock Owners Manual
Battery Installation
The Bauer NE uses 4 AA batteries for operation. We do not recommend zinc carbon batteries for this application.
Batteries not included.
NOTE:
Fresh batteries should be installed as necessary. Battery Life is highly dependent upon battery
quality, usage, and environment (temperature). Remove batteries if the lock will not be used for
extended periods of time.
The following steps are shown on the enclosed Battery Installation diagram:
1.
Remove (2) 4x40 screws (Fig. 3A) from Battery Compartment Lid. These screws are very small so please
take care in removal and installation. A magnetic tip #0 point Phillips Screwdriver is recommended.
2.
Install the AA batteries (Fig. 3B) in accordance with the orientation shown in the Battery
Compartment(Fig. 3C). The batteries will fit tightly.
3.
Install Battery Compartment Lid (Fig. 3D) by aligning the (3) tabs on the lid with the (3) slots (Fig. 3E) on
the Inside Plate Assembly. These tabs act as a hinge for closing the Battery Compartment Lid.
4.
Install the (2) 4x40 screws (Fig. 3A) back to attach the Battery Compartment Lid to the Inside Plate
Assembly.
1.
Align tab (Fig. 4A) with small, square slot in receptacle (Fig. 4B).
2.
With plug aligned, insert into receptacle until a click is heard.
Fig. 4
B
A
Battery Plug Instructions
The following image shows a detailed view of the plug and receptacle for plugging the inside plate assembly into
the receptacle on the Bauer housing.
Fig. 3
E
Plug
A
D
B
C
