Rev: 11.29.18
Page 16
CCD-0001755
Auto Level
1.
Prior to auto leveling, make sure the trailer is unhitched from the tow vehicle and the tow vehicle is
parked a safe distance away from the trailer.
2.
Press the “ON/OFF” button (Fig. 29A) and then press “AUTO LEVEL” (Fig. 29B).
NOTE:
Once the automatic leveling cycle has been started, it is important that there is no movement in the
trailer until the trailer has completed the leveling process. Failure to remain still during the leveling
cycle could have an effect on the performance of the leveling system.
NOTE:
Pressing any button during an Auto Level sequence will abort the auto leveling cycle.
NOTE:
Auto Leveling sequence may vary slightly based on the height of the trailer coupler prior to leveling.
NOTE:
Sequence may vary slightly based on the height of the trailer coupler prior to leveling.
3.
When the Auto Level sequence begins:
A.
The system checks that the rear jacks are retracted.
B.
The Power Tongue Jack may adjust depending on the orientation of the trailer.
C.
Front jacks will extend until movement of the trailer is sensed.
D.
The Power Tongue Jack will then retract.
E.
The front jacks will extend/retract near level.
F.
Rear jacks will extend and ground.
G.
Trailer will level front-to-rear and then side-to-side.
H.
The Auto Level sequence will ground all jacks to ensure all foot pads are on the ground. Once this
has been completed the LCD screen will read "AUTO LEVEL SUCCESS."
4.
The LED screen will then read "READY" followed by the current battery voltage. The green LED in the
center of the four leveling jack buttons will be illuminated (Fig. 30A).
NOTE:
If the "AUTO LEVEL" sequence does not perform as described above, place the system in manual
mode and test that the jacks operate correctly by pushing their coordinating buttons on the touch
pad; i.e. "FRONT" button operates only the front jacks, etc. If the jack functions are incorrect, check
that the correct jack wiring harnesses are plugged into the correct ports on the controller.
Fig. 29
A
B
Fig. 30
A