Rev: 11.29.18
Page 7
CCD-0001755
Fig. 8
Fig. 9
A
4.
Align the 3 holes in the Power Tongue Jack mounting plate (Fig. 8A) with the 3 holes in the coupler
(Fig. 8B).
5.
Secure the Power Tongue Jack to the coupler plate with three
3/8
" - 16 x 1" serrated flange Grade 5 Zinc
coated bolts (Fig. 9A).
6.
Connect the two Deutsch Connectors from the jack to the Tongue Jack Harness.
7.
Connect the power wire from the Power Tongue Jack to a 30 amp fuse, then to a grounded 12V power
supply on the trailer.
NOTE:
The Power Tongue Jack has an option to replace the foot pad or attach the Drop Leg foot pad.
8.
Reattach the foot pad to the jack leg by sliding the foot pad back over the bottom of the jack leg.
Secure it with the clevis pin and cotter pin which were previously removed (Fig. 6).
NOTE:
The Power Tongue Jack has an option to replace the foot pad with the Drop Leg foot pad.
9.
If using the Drop Leg foot pad, attach the foot pad (Fig. 10C) to the jack leg (Fig. 10A). Secure it with
the snapper pin (Fig. 10B).
Fig. 10
C
A
B
A
B
