Rev: 11.29.18
Page 12
CCD-0001755
LCI Electronic Leveling Touch Pad
1.
Determine where to mount the touch pad. The touch pad should be mounted in a compartment on
the side of the trailer so the operator will have a view of the coupler while using the touch pad.
2.
Remove the faceplate of the touch pad (Fig. 20B) from the mounting bezel (Fig. 20A).
3.
Cut a hole in the wall of the compartment 3
3/8
” wide by 2
3/4
” high (Fig. 21) so the top and bottom
horizontal cuts are parallel to the floor of the compartment.
4.
Feed the touch pad harness through this hole and run it to the compartment where the controller is
mounted. Plug the harness into the appropriate connector on the controller.
5.
Insert the touch pad bezel (Fig. 22A) into the cutout and attach it with four #8 x 1" wood screws
(Fig. 22B) with sufficient length to thread into the compartment wall.
6.
Plug the touch pad harness into the connector on the back of the touch pad faceplate and snap the
faceplate into the bezel (Fig. 23).
Fig. 21
Fig. 23
Fig. 20
A
B
2
3/4
"
3
3/8
"
Fig. 22
A
B
