Rev: 11.29.18
Page 9
CCD-0001755
Installing Leveling Sensors
The Leveling Sensors (Fig. 13) must be installed on cross-members in line with or behind the rear jacks, and
in line with, or in front of, the front jacks, centered curbside to roadside on the trailer with the arrows on
the top of the sensor pointing the correct direction (Fig. 14). See (Fig. 11), Sections A and B and Figure 12,
Section B for location clarification.
Fig. 13
NOTE:
The following process will be repeated for both sensor installations.
NOTE:
Leveling sensor mounting plate might be pre-installed by LCI, if so perform step 2 and step 4.
1.
Dry fit the mounting plate (Fig. 15C) and the leveling sensor (Fig. 15B) to the cross-member (Fig. 15A).
The pre-drilled holes in the plate are for mounting the sensor to the plate. Mark on the plate where the
sensor will set.
Fig. 14
Fig. 15
A
B
C
NOTE:
Leave space between the sensor (Fig. 15B) and cross-member (Fig. 15A) so the wire harness will not
be pinched.
NOTE:
The wire harness must be oriented towards the front of the trailer (Fig. 11 and Fig. 12). Proper
orientation of the wire harness is imperative for correct operation of the leveling system.
