Rev: 10.29.18
Page 6
CCD-0001532
Hitch Recognition
1. Turn on touchpad.
2. Press the LEFT and RIGHT jack buttons simultaneously (Fig. 1H and 1I).
3. The front of the trailer will raise to the height where the auto-level sequence was started.
NOTE: If the auto-level sequence was started with the front of the trailer in a below-level condition,
the hitch recognition will not function and the LCD will display Feature Disabled. For the hitch
recognition feature to function, the auto-level sequence MUST be started with the front of the
trailer above level.
4. Connect tow vehicle and make sure travel trailer and hitch are connected and locked.
5. Press the UP arrow (Fig. 1A) until AUTO RETRACT appears in the LCD screen.
6. Press the ENTER button (Fig. 1C). The system will immediately retract all jacks.
Manual Operation
1. Front jacks
NOTE: The front jacks will operate manually any time system is on except in AUTO MODE.
A. Press the POWER button (ON/OFF) (Fig. 1K) to turn system on.
B. Press the UP arrow (Fig. 1A) once or until screen reads MANUAL MODE (Fig. 2).
C. Press the ENTER button (Fig. 1C) once while screen reads MANUAL MODE (Fig. 2).
D. Press the FRONT jack button (Fig. 1G) to extend front jacks.
E. Press the RETRACT button (Fig. 1D) and the LED (Fig. 4) comes on.
F. Press the FRONT button (Fig. 1G) to retract front jacks.
NOTE: If the LED indicator light (Fig. 4) is on, jacks will retract. If the LED indicator light is off, jacks will extend.
G. Press the POWER button (ON/OFF) (Fig. 1K) to turn system off.
H. After three minutes of inactivity, the system will automatically turn off.
Fig. 4
2. Level Up leveling jacks - EXTEND
A. Press the POWER button (ON/OFF) (Fig. 1K) to turn system on.
B. Press the UP (Fig. 1A) or DOWN arrows (Fig. 1B) to scroll through selections until MANUAL MODE is
displayed.
C. Press the ENTER button while MANUAL MODE is displayed (Fig. 2).
NOTE: By pressing the RIGHT jack button, the curbside Level Up jacks operate. By pressing the LEFT jack
button, the roadside Level Up jacks operate. Follow similar procedures for front and rear jacks.
NOTE: To extend, the RETRACT button's LED light (Fig. 4) should be off.
3. Level Up leveling jacks - RETRACT
A. Press the RETRACT button and the LED indicator light (Fig. 4) will come on.
B. Press the REAR jack button to retract all Level Up jacks.
NOTE: The side-to-side movement in manual mode is limited to five degrees of tilt.
Fig. 4
PN 234802 - Black
PN 421484 - Gray
DISCONTINUED
