Rev: 10.16.20
Page 1
CCD-0003782
PROJECT 2000
®
TOPLINE BEDLIFTING PLUS
PROGRAMMING STOP POSITIONS (EU)
TI-360
POWER AND MOTION
Purpose
This document outlines the procedure for programming new stop positions in the event flash memory has
been emptied (erased).
Note:
Images used in this document are for reference only when assembling, installing and/or operating
this product. Actual appearance of provided and/or purchased parts and assemblies may differ.
Safety
Read and understand all instructions before installing or operating this product. Adhere to all safety labels.
Procedure
For the controller to work properly, at least one stop position (limit) must be set. Typically, this is the lowest
position the bed can reach.
The controller can be programmed with up to five stop positions, and will automatically detect the lowest of
those positions as its limit-reference. The programmed stop positions are stored in flash memory.
When activating the system, if the red lights (Fig. 1E and F) start flashing one second on/one second off,
then flash memory is empty. The existing stop positions are erased as soon as the programming mode
is selected. If the board loses power at any position before step 6, the stop positions will not be saved to
memory. When activating it after power is restored the red warning lights (Fig. 1E and F) will be flashing.
The bed can only be raised when a new setting is stored in memory.
Programing New Stop Positions
To create a new, or sequence of, stop position(s), do as follows;
Note:
Some control panels have a keyed switch, others (Fig. 1) do not.
1.
Make sure the controller is activated.
A.
If the two arrow-shaped lights (Fig. 1A) are on, proceed to step 2.
B.
If the arrow lights do not come on immediately after the controller is activated, press and hold the
UP button (Fig. 1B) for about six seconds until the lights turn on.
C.
If after six seconds the lights do not turn on, make sure the system has power.
I.
Unplug the harness from the back of the controller, wait a moment then reconnect.
II.
Repeat steps A. or B.
the “CAUtIoN” symbol above is a sign that a safety risk is involved and may cause personal injury
and/or product or property damage if not safely adhered to and within the parameters set forth
in this manual.
Moving parts can pinch, crush or cut. Keep clear and use caution.
