4
574-537-8900
Rev: 11.11.20
Waste Master
®
Tubular
Storage Enclosure
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002186
Manual information may be distributed as a complete
document only, unless Lippert Components provides
explicit consent to distribute individual parts.
All manual information is subject to change without
notice. Revised editions will be available for free
download at
. Manual information is considered
factual until made obsolete by a revised version.
Please recycle all obsolete materials and contact
Lippert Components with concerns or questions.
A
7.
With storage tube securely attached to the enclosure,
tighten the hose clamp.
B
C
Storage Tube
The storage tube, end cap, all-purpose cement and hose
clamp will need to be purchased separately from the
enclosure kit. The tube can be purchased from most home
improvement or larger plumbing stores. The tube must be 4”
in diameter and at least 10’ long which can be cut to size.
NOTE:
If there is limited access for installation, it may be
necessary to cut the 10' tube into two shorter parts and
join with a coupler to make up the total length needed.
Attaching the Storage Tube to the Enclosure
1.
Using a tape measure, mark a 3
1/8
” deep by 2” wide
notch on the end of the storage tube
(Fig.6B)
.
NOTE:
Orange lines indicate where material is being removed.
2.
Using a saw, cut the notch into the storage tube so that
the tube will slide all the way onto the outlet on the back of
the enclosure
(Fig.6A)
. The tube should fit snugly.
NOTE:
Make sure the saw is equipped with a fine-toothed
blade intended for metal or PVC materials.
3.
Using a tape measure, determine the length of storage
tubing needed for storage of the Waste Master sewer hose.
4.
Cut the 10' piece of pipe to fit the Waste Master sewer
hose when fully collapsed allowing for variation.
5.
Apply all-purpose cement to the inside edge of the end
cap and around the newly cut end of the storage tube.
6.
Prior to attaching the tube to the enclosure, slide the hose
clamp onto the cut end of the tube. The hose clamp should
be positioned just behind the notch in the tube made in step 2
(Fig. 6C)
. Do NOT use glue to attach storage tube.
NOTE:
Green lines indicate where the hose clamp is positioned.
Fig.6
