12
432-LIPPERT (432-547-7378)
Rev:06.30.22
JT’s Strong Arm
™
Travel Trailer
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-002345
Installation
1.
Remove the fastening hardware
(Fig. 13A)
that holds the
foot pad
(Fig. 13B)
onto the jack
(Fig. 13C)
.
NOTE:
Set hardware aside for later reuse.
2.
Align adapter plates
(Fig. 14A)
to holes in foot pad.
Place the smaller half down and on the outside of footpad
brackets
(Fig.14B)
.
Fig.14
Fig.15
Fig.13
3.
Loosely install
3/8
” - 16 x 4” swing bolt
(Fig.15A)
, two
3/8
” SAE flat washers
(Fig. 15B)
, a
3/8
” - 16 nylon lock nut
(Fig. 15C)
and a
3/8
” - 16 lift handle
(Fig15D)
to attach the
adapter plates to foot pad.
NOTE:
Adapter plate holes may need to be enlarged using
either a
3/8
” or
25/64
” drill bit.
4.
Tighten swing bolt enough so that it will only pivot by
using a screwdriver for leverage.
A
A
B
C
A
A
A
A
B
B
A
B
C
D