English
CCD-0005520 Rev: 04-22-22
- 7 -
frame of the module is generally recommended.
–
Always observe the instructions and safety precautions included with the module
support frames.
–
Before installing modules on a roof, ensure that the roof construction is suitable.
In addition, any roof penetration required to mount the module must be properly
sealed to prevent leaks.
–
Observe the linear thermal expansion of the module frames [the recommended
minimum distance between two modules is 7/16" (10mm)].
–
Always keep the back-sheet of the panel free from foreign objects or structural
elements, which could come into contact with the panel, especially when the
panel is under mechanical load.
–
Ensure panels are not subjected to wind or snow loads exceeding the maximum
permissible loads (586lbs/266kgs), and are not subject to excessive forces due
to the thermal expansion of the support structures.
Secure the Solar Panel to the RV Roof
Mount the solar panel through the such that at least 6 of the mounting feet have
screws penetrating the metal or wooden framing trusses. For fixed mounting, the
points should be installed with M8*25 bolts and nuts in the frame on the long side of
the panel, as shown below:
ELECTRICAL CONNECTION
To power the Solar Photovoltaic System properly, the following Furrion components
are also required except the solar panel. Please contact Furrion authorized dealer to
purchase the product(s) as required and refer to the individual instruction manual that
comes with the product to set up the system.
Furrion Model#
Description
C-FSFP37MW-A02
L-Bracket
FSCC30PW-BL/FSCC60PW-BL
MPPT Solar Charge Controller
C-FSCC60PW-A01/C-FSCC60PW-A02
Temperature Sensor
